Image: u/WinterPublic2445 on Reddit · The e-ink touch dashboard on the wall
An interactive e-ink touch dashboard for Home Assistant
A Home Assistant user built a fully interactive touch dashboard on a Seeed reTerminal E1003 e-ink device, written in ESPHome with Claude Code.
Credits
- Reddit poster WinterPublic2445 Source ↗
Earliest dated source:
The full story
A Home Assistant user built a fully interactive touch dashboard on a Seeed reTerminal E1003, a 10.3-inch ESP32-S3 e-paper display with 16 grey levels.
It was written in ESPHome with Claude Code. Plugged into mains power it updates instantly; page changes take a moment to refresh, while small buttons respond almost at once. The maker credits Seeed's open hardware for allowing ESPHome as well as its own firmware.
How it was done
Tools
Themes
Loading themes…
Sources
From a short post by the maker, so the details are as they tell them.
- Reddit: Interactive eink Touch DashboardReddit poster: WinterPublic2445Posted
The maker's post in r/homeassistant.
- The project: seeedstudio.com
The project on seeedstudio.com.
- Reddit: Home Assistant Touch DashboardReddit poster: WinterPublic2445Posted
The maker's post in r/eink.